Commissioning; Transport; Maintenance And Cleaning; Storage - Scheppach Df-24T Original Bedienungsanleitung

9.

Commissioning

m Attention!
Always make sure the device is fully assembled before
commissioning!
Setting up
1. Always place the device on a flat, stable surface.
Keep an area of free space of 50 cm around the
device. The device is not suitable for use in a cup-
board or outdoors.
2. Connect the mains plug to the socket.
Switching the device on/off (Fig. A)
To select the desired fan speed, turn the on/off switch
(7) to the corresponding position.
Position Function
0 Off
1 Minimum speed
2 Medium speed
3 Maximum speed
10. Transport (Fig. A)
Always switch the device off before transport and dis-
connect it from the power supply.
To transport, lift the device by the transport handle (2)
and move it using the transport wheels (6).

11. Maintenance and cleaning

m WARNING!
Pull out the mains plug before carrying out any setting,
servicing or repair work!
General maintenance tasks
• Always keep the cooling air openings in the housing
clean and clear for air circulation.
• Rub the device clean with a clean cloth or blow it off
with compressed air at low pressure.
• We recommend that you clean the device directly
after every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior.
• There are no parts which can be repaired by the
user within the device. Never try to repair the device
yourself. Always contact a qualified specialist.
Replacing the connection cable
If the mains connection cable of the device is dam-
aged, it must be replaced by the manufacturer, their
service department or a similarly qualified person to
avoid dangers.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Carbon brushes
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

12. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging.
Cover the power tool to protect it from dust or moisture.
Store the operating manual with the power tool.

13. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The cus-
tomer's mains connection as well as the exten-
sion cable used must also comply with these reg-
ulations.
Important information
In the event of overloading, the motor will switch itself
off. After a cool-down period (time varies) the motor
can be switched back on again.
www.scheppach.com GB | 21