Troubleshooting - ClearSound AMPLICALL 20 Bedienungsanleitung

Trouble shooting
Symptom
No incoming call yet
the Amplicall20 rings
automatically or
rings continuously.
The shaker vibrates
automatically or
continuously.
The strobe LED
flashes automatically
or continuously.
The red low battery
LED flashes
automatically.
When there is an
incoming call but no
ringing can be heard.
INSTALLATION
Solution
1) Check the batteries are
2) Check the power adaptor is
3) Turn off the power for 10
1) Replace the batteries.
2) Turn off the power for 10
1) Check it is connected to the
2) Check the batteries are
3) Check the volume switch is
4) Check it is connected to the
5) Check the alarm mode
10
inserted correctly.
connected correctly.
minutes and then turn it
back on.
minutes and then turn it
back on.
power adaptor correctly.
inserted correctly.
on.
line cord correctly.
selection switch position is
correct