Installing The System Into The Rack; Installing The System Into A Telco Rack - Bosch DLA-AIOL1 Schnellstartanleitung

26 en | System Setup - Hardware
To install the Outer Rails to the Rack
1.
2.
3.
4.
Locking Tabs
–
2.4.4

Installing the System into the Rack

To install the Chassis into a Rack
1.
2.
3.
4.
2.4.5

Installing the System into a Telco Rack

To install the system into a Telco type rack, use two L-shaped brackets on either side of the
chassis (four in total). First, determine how far the system will extend out the front of the
rack. Larger chassis should be positioned to balance the weight between front and back. If a
bezel is included on your system, remove it. Then attach the two front brackets to each side of
the chassis, then the two rear brackets positioned with just enough space to accommodate
the width of the telco rack. Finish by sliding the chassis into the rack and tightening the
brackets to the rack.
- | V1 | 2011.03
Secure the back end of the outer rail to the rack, using the screws provided.
Press the button where the two outer rails are joined to retract the smaller outer rail.
Hang the hooks of the rails onto the rack holes and if desired, use screws to secure the
front of the outer rail onto the rack.
Repeat steps 1-3 for the remaining outer rail.
Both chassis rails have a locking tab, which serves two functions. The first is to lock the
system into place when installed and pushed fully into the rack, which is its normal
position. Secondly, these tabs also lock the system in place when fully extended from the
rack. This prevents the system from coming completely out of the rack when you pull it
out for servicing.
Extend the outer rails as illustrated above.
Align the inner rails of the chassis with the outer rails on the rack.
Slide the inner rails into the outer rails, keeping the pressure even on both sides. When
the chassis has been pushed completely into the rack, it should click into the locked
position.
Optional screws may be used to secure the to hold the front of the chassis to the rack.
Quick Installation Guide
1400 Series/8-bay IP Video Storage System
Bosch Sicherheitssysteme GmbH