Hiton HP 145 Bedienungsanleitung Seite 15

and can continue operating in this
mode on a continuous basis:
30 kW; 1,25 kg/h - HP 145, HP 145R
The second gear, with increased per-
formance can be activated by selec-
ting „+" on the control panel:
42 kW; 3,75 kg/h - HP 145, HP 145R
Each time Stop button is pressed
followed by pressing the Start button
during operation will result in swit-
ching into the Heating up mode of the
burner.
Shutting off
Press Stop on the control panel
(yellow diode goes off), pump stops
feeding fuel onto the vaporising pan,
and ventilation fan works only until
the burner has cooled off.
The device must not be unplug-
ged for as long as the ventilation
fans are working, this can be done
only after the burner has cooled
down. The burner switches off au-
tomatically. Please remember that
after switching off the device, the
cast-iron pan remains hotter
for longer (depending on the tempe-
rature in the room) and the heater
cannot be re-engaged until it cools
down completely.
HITON - heat your home, not the planet
Maintenance
The burner requires various mainte-
nance works. Following producer's
recommendations regarding main-
tenance will assure failure-free and
safe functioning of the device.
Vaporising pan and elements of the
combustion chamber (cylinder, ring
and lid) should be cleaned daily.
Check if the oil overflow pipe is unob-
structed (this pipe is located in the
lower part of the combustion cham-
H-B ber, directly above the overflow
tank), and clean if necessary.
Clean the burner basin located inside
the combustion chamber at least once
a week (vaporising pan, deflector and
lid).
Check if air inlets in the lower and up-
per part of the combustion chamber
are not obstructed.
Clean the oil feed line once a week.
The maximum time of operation wi-
thout cleaning the line feeding oil onto
the vaporising pan is approximately
7-14 hours (depending on the type of
oil used for heating).
Clean the fuel tank and oil pump
filters during heating season.
If the heater is not used for a longer
period of time, the combustion cham-
ber and the tank should be cleaned
thoroughly, and then covered with a
thin layer of oil in order to prevent
corrosion.
It is recommended to have all
maintenance works done each se-
azon by an authorised dealer
10. Failures and their
remedies
In case of a failure of the device, the
following list may help identify its cau-
se and remedy. Generally, it should be
easy to fix. The following are the most
common problems. Digits represent
possible causes. The order of digits
suggests gradation of probable cause
of the failure.
CAUTION!
Unplug the device before star-
ting to fix the problem.
ENG
| 15