Dometic VT100WiFi Montage- Und Bedienungsanleitung Seite 11

VT100WiFi
6.2 Preparing the transmitter for installation
!
CAUTION!
Select the place of installation for the transmitter so that it is not able to injure any
vehicle passengers at all (e.g. from braking suddenly or car accident).
Observe the following installation instructions:
• Install the transmitter so that as few objects as possible are situated between the transmitter and
receiving device. Moving the antenna can help if there is a poor connection.
• If possible, install the transmitter in the vehicle.
The housing is splash-water protected and can be mounted outside on the vehicle.
Nevertheless, you should select a place that is well-protected. Select a place that is protected
against mechanical impact (e.g. flying stones) if you install the transmitter on the outside of the
vehicle.
• The installation location should be flat.
• Before drilling each hole, ensure there is sufficient space on the other side for the drill head to
emerge (fig. 4, page 5).
• Make sure you can lay the connection cable from the transmitter to the camera.
I
NOTE
The image is sent from the transmitter to the receiving device. To ensure flawless
functioning, you need to check whether the wireless transmission is stable before final
installation.
To perform the installation, proceed as follows:
➤ Attach the transmitter and the antenna in the installation location provisionally.
➤ Install the camera.
➤ Start the transmitter and put your receiver in the selected position (e.g. driver's cab) and
activate the app, see chapter "Using the transmitter and the app" on page 14
If the camera image is transmitted steadily (no flickering), you can install the transmitter
permanently.
If there is interference, such as flickering images, turn or move the antenna slightly and test the
transmission again.
EN
Installing the transmitter
11