Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Components List
1. Dust Container
2. Locking Button
3. On/Off Switch
4. Charging indicator lamp
5. Dust Brush
FIXATION OF THE WALL-MOUNTED BRACKET
• Measure the distance between the holes situated at the back of the
bracket and drill two holes in the wall at the same distance.
• Put a plug in the holes and screw the screws in the holes by letting
them more or less 4 millimetres out of the wall.
• Fix the bracket by putting the screws into the widest part of the
holes situated at the back of the bracket and slide the bracket
downwards.
INSTRUCTIONS FOR USE
• The vacuum cleaner is powered by batteries.
• Plug in the charger's plug into the unit's phone jack that is on the
bottom of the handle for charging. When the unit is being charged,
the charging indicator is on (which is shown by red light). Once fully
charged just take out the unit for use anywhere.
• After use, recharge the unit as instructed above. For safety purposes
only use the charger supplied by the manufacturer.
• Before use, please charge the vacuum for at least 16 hours.
• Switch the unit on and off by pressing the on/off switch.
• Press the release button, then take out the nozzle. There is a
sponge inside the filter bracket.
• For a good vacuuming result, always start with a clean filter.
MAINTENANCE
Cleaning the dust filter and dust container:
• Detach the dust container from the motor unit by pressing down the
Werbung
Inhaltsverzeichnis
