Start-Up; Settings On The Saw - ATIKA BS 205-2 Originalbetriebsanleitung

Start-up

Mains connection
Compare the voltage listed on the machine's type plate, e.g.
230 V, with the mains voltage and connect the machine to a
suited and and properly earthed electrical socket.

AC-motor
Use an electrical socket with a rated voltage of 230 V with a
fault-current circuit breaker (30 mA).

Main fuse: 10 A slow
Use an connecting or extension cable in compliance with IEC
60245 (H 07 RN-F) having a core cross-section of at least:
 1.5 mm² for cable lengths up to 25 m
 2.5 mm² for cable lengths over 25 m
ON/OFF switch
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Switching on
Press the green button

Restart protection in case of power failure
The device cuts off automatically in case of power failure.
To restart, push the green button
Switching off
Press the red button
Saw band selection
The saw band delivered by standard is suitable for wood and
most plastics.
Consider when selecting the saw band,
 that no edgeless or damaged saw bands are used.
 that the selection of the saw band and the number of
revolutions is suitable for the material to be cut.
Connect splinter extraction
In closed rooms work only with a splinter extraction
(air speeds at suction socket of the saw  20 m/sec.).
Sawing without splinter extraction only
 for short-time service (up to 30 min.)
 or with a protective mask
 or open-air

If you do not connect splinter extractor sawdust will
concentrate which you have to remove regularly.
Connect sawdust extraction system or small dust extractor
with a suitable adapter to the sawdust suction socket (16).
on switch.
.
on switch.

Settings on the saw

Saw band tension
A too high stress can result in the break of the saw
band. A too less stress can result in the drive wheel
sliding through and then result in the stop of the saw
band.
You can check the stress:
Put the saw band coping (11) completely upwards (see
„Adjustment of the saw coping" page 20) and press with
the finger in the middle between the saw table and the
upper saw coping transversally against the saw band
 it shall only be possible to push the saw band in
laterally by 1 – 2 mm.
With the adjusting wheel (1) the stress of the saw band
can be corrected.
Increase stress (+)
 turn adjusting wheel clockwise
Reduce stress (-)
 turn the adjusting wheel anti-clockwise.
Incline of the upper band saw roll
Open the upper case door (2) to be able to check the run
of the saw band by turning the band saw roll (13) manually
and clockwise.
With the adjusting wheel (20) the incline of the upper band
saw roll (13) can be changed. The adjusting causes that
the saw band runs in the centre of the band saw roll.
Before adjusting release the fixation nut (H).
Saw band runs backwards (+)
 turn the adjusting wheel clockwise
Saw band runs forwards (-)
 turn the adjusting wheel anti-clockwise
After adjusting refasten the fixation nut (H).
Transverse adjustment of saw table
Loosen the fixing screws (C / D).
The saw table (6) can continuously be inclined against the
saw band up to 45°.
Retighten the fixing screws.
Parallel stopper
The parallel stopper (8) is clamped on the saw table. It
can be assembled on the right or on the left of the saw
band.

Pay attention to the right adjustments of the parallel
stopper.
19