Teach-In Of The Device - Alpha IP BDT 24001 Bedienungsanleitung

Alpha IP BDT 24001
I
II
Commissioning
6. Connect the external conductor to connection terminal L.
7. Connect the neutral conductor to connection terminal N.
8. Connect the neutral conductor of the lamp to the neutral conductor
of the building installation.
9. Screw the device to the flush-type box.
The system key must be in the left upper corner for the installation.
10. Install the adapter to the rocker (see I in figure on the left).
11. Fix the rocker together with the adapter into the frame on the actuator
(see II in figure on the left). Both catches must fit to the oblong holes.
12. Connect to the mains network.
6.2

Teach-in of the device

Prior to operating the dimming actuator for brand switches, it must be
integrated into the Alpha IP system via the Access Point (HAP 21001).
For this, teach-in the respective device as follows.
Ö The Alpha IP Access Point has been set up via the Alpha IP app.
Ö The actuator is assembled and installed.
1. Open the Alpha IP app on your smart phone.
2. Select the menu item Teach-in device.
The teach-in mode is active for three minutes after installation. The
teach-in mode can be activated manually by removing the rocker and
short pressing of the system key.
3. The device will be displayed automatically in the app.
30 DEU ENG