Unit Care - Technics STC700DE Bedienungsanleitung

"F " (" " stands for a number.)
≥ There is a problem with this unit.
– Is this unit placed in an extremely hot place?
If so, move this unit to a cooler place and wait a few moments
and then try to turn it on again.
If the problem persists, write down the displayed number,
disconnect the AC mains lead and consult your dealer.
"Load Fail"
≥ The firmware on the USB flash memory cannot be found.
≥ Download the latest firmware on the USB flash memory
and try again. ( 27)
"No Network Available"
≥ This unit is not connected to the network.
Check the network connection. (
"No Memory"
≥ There are no preset DAB/DAB+ stations to select. Preset
some channels. (
"No Signal"
≥ This station cannot be received. Check your antenna.
"Not Valid"
≥ The function you have tried to use is not available with the
current settings. Check the steps and settings.
"PGM Full"
≥ The number of programmed tracks is more than 24.
"Please Wait"
≥ This is displayed, for example, when this unit is turned
on/off. (For up to 1 minute and 30 seconds)
"Remote " ("
≥ The remote control and this unit are using different codes.
Change the code on the remote control.
– When "Remote 1" is displayed, press and hold [OK] and [1] for
at least 4 seconds.
– When "Remote 2" is displayed, press and hold [OK] and [2] for
at least 4 seconds.
"Remote Mode"
≥ Basic operations using any of the basic control switches on
the main unit or the buttons on the remote control cannot
be performed. (This happens when music stored on a
DLNA server is played back on this unit (DMR), for
example.)
≥ Use the connected device for basic playback control.
32
(32)
12)
24)
" stands for a number.)
"Scan Failed"
≥ Stations are not receivable. Check your antenna and try
Auto scanning. ( 24)
If "Scan Failed" is still displayed, find the best signal
reception with the "Manual Scan" tuning function. (
"Searching"
≥ The unit is checking the DLNA server on the network.
"Unlocked"
≥ "PC" is selected, but a PC is not connected. Check the
connection with the PC. (
≥ The sampling frequency components, etc. of the audio
signals are not input correctly.
– About supported format, refer to "File format" (
"USB Over Current Error"
≥ The iPhone/iPad/iPod or USB device is drawing too much
power. Disconnect the iPhone/iPad/iPod or USB device
and turn the unit off and on again.
"Hub Device Not Supported"
"Device Not Recognized"
"Not Supported"
"USB Device Not Supported"
≥ You have connected an iPhone/iPad/iPod or USB device
that is not supported.
– If the iPhone/iPad/iPod is compatible, turn it on and connect it
correctly.
≥ The format of the file on the iPhone/iPad/iPod or USB
device is not supported.
– About supported format, refer to "File format" (
∫ About Network service
The services through network service are operated by their
respective service providers, and service may be
discontinued either temporarily or permanently without
notice. Therefore, Panasonic will make no warranty for the
content or the continuity of the services.

Unit care

Pull out the AC mains lead from the outlet before
maintenance. Clean this unit with a soft cloth.
≥ When dirt is heavy, wring a wet cloth tightly to wipe the dirt, and
then wipe it with a soft cloth.
≥ Do not use solvents including benzine, thinner, alcohol, kitchen
detergent, a chemical wiper, etc. This might cause the exterior
case to be deformed or the coating to come off.
24)
20)
35)
35)