Listening To Dab/Dab - Technics STC700DE Bedienungsanleitung

Listening to DAB/DAB+

You can preset up to 20 channels.
Preparation
≥ Make sure that the DAB antenna is connected. (
≥ Press [NWP] and then [N INPUT O] below [NWP]
repeatedly to select "DAB/DAB+".
– If you select "DAB/DAB+" for the first time, the system will start
the "DAB auto scan" procedure.
DAB auto scan
1
Press [NWP].
2
Press [MENU].
3
Press [3, 4] repeatedly to select "Auto
Scan" and then press [OK].
4
Press [3, 4] to select "Yes" and then press
[OK].
≥ "Auto Scan" is displayed.
DAB manual tuning
To find the best antenna position, use manual tuning to
search selected DAB frequency block.
1
Press [NWP].
2
Press [MENU].
3
Press [3, 4] repeatedly to select "Manual
Scan" and then press [OK].
4
Press [3, 4] to select a frequency block to
scan and then press [OK].
Memory presetting
1
Press [NWP].
2
Press [6] or [5] to tune in to the station.
3
Press [PGM].
4
Press the numeric buttons to select a preset
number.
≥ Do steps 1 through 3 again to preset more stations.
≥ A station previously stored is overwritten when another station is
stored in the same preset number.
≥ You cannot preset a station when the station is not broadcasting or
when you have selected a secondary service.
≥ Previous station memory is cleared during auto scan.
24
(24)
Selecting a preset station
10)
1
Press [NWP].
2
Press the numeric buttons, [:] or [9] to
select the preset station.
Viewing available information
You can view information about the DAB broadcast,
programme type, ensemble label and frequency.
1
Press [NWP].
2
Press [INFO] to view available information.
DAB Secondary
Some DAB/DAB+ stations provide a secondary service as
well as the primary service. If the station you are listening to
is providing secondary service, "
1
Press [NWP].
2
Press [MENU].
3
Press [3, 4] repeatedly to select
"Secondary" and then press [OK].
4
Press [3, 4] to select the secondary
service and press [OK].
≥ The setting will go back to primary service when changes are
made (e.g. the station is changed).
DAB signal quality
When adjusting the antenna, you can check the reception quality.
1
Press [NWP].
2
Press [MENU].
3
Press [3, 4] repeatedly to select "Signal
Quality" and then press [OK].
4
Press [3, 4] to select frequency.
e.g.,
Frequency block
" will be displayed.
Frequency
Reception quality
0 (poor) to 8 (excellent)