Firmware-Updates; Update Via Internet - Technics STC700DE Bedienungsanleitung

Firmware updates
Occasionally, Panasonic may release updated firmware for
this unit that may add new features or improve the ways
existing features operate. These updates are available free
of charge.
≥ For the update information (new or improve features), refer
to the following website.
www.technics.com/support/firmware/
Downloading takes approx. 10 minutes.
Do not disconnect the AC mains lead or lower the
power switch lever to the [OFF] position while one of
the following messages is displayed.
"Linking" or "Updating %"
≥ During the update process, no other operations can be performed.
≥ If there are no updates, "Firmware is Up To Date" is displayed. (No
need to update it.)
≥ Updating the firmware may reset the settings.

∫ Update via internet

Preparation
≥ Connect this unit to the network. (
– Make sure that the network is connected to the Internet.
1
Press [NWP].
2
Press [HOME].
3
Press [3, 4] repeatedly to select "SETUP"
and then press [OK].
4
Press [3, 4] repeatedly to select "F/W
Update" and then press [OK].
5
Press [3, 4] to select "Internet" and then
press [OK].
6
Press [3, 4] to select "Yes" and then press
[OK].
≥ The progress is displayed as "Updating
updating. ( stands for a number.)
≥ When the update has finished successfully, "Success"
is displayed.
7
After "Success" is displayed, disconnect the
AC mains lead and then reconnect it after 3
minutes.
≥ Downloading may take longer or may not work properly depending
on the connection environment.
12)
%" while
∫ Update via USB flash memory
Preparation
≥ Download the latest firmware on the USB flash memory.
For details, refer to the following website.
www.technics.com/support/firmware/
≥ FAT16 and FAT32 file systems are supported.
1
Connect the USB flash memory with new
firmware.
2
Press [NWP].
3
Press [HOME].
4
Press [3, 4] repeatedly to select "SETUP"
and then press [OK].
5
Press [3, 4] repeatedly to select "F/W
Update" and then press [OK].
6
Press [3, 4] to select "USB" and then press
[OK].
7
Press [3, 4] to select "Yes" and then press
[OK].
≥ The progress is displayed as "Updating
updating. ( stands for a number.)
≥ When the update has finished successfully, "Success"
is displayed.
8
After "Success" is displayed, disconnect the
AC mains lead and then reconnect it after 3
minutes.
≥ Downloading may take longer depending on the USB flash
memory.
∫ Checking the firmware version and the
model number
1 Press [NWP].
2 Press [HOME].
3 Press [3, 4] repeatedly to select "SETUP" and then
press [OK].
4 Press [3, 4] repeatedly to select "F/W Version" and
then press [OK].
≥ The firmware version and the model number are displayed.
≥ Press [OK] to exit.
%" while
27
(27)