Siemens Gigaset SX686 WiMAX Installationsanleitung Seite 27

Gigaset SX686 WiMAX / de-en / A31008-N919-R101-2-ZD43_22-10-2008 / qig_SX686_685.fm / 23.10.2008
Connecting a PC wired
You can connect wired or wireless PCs to your Gigaset SX686 WiMAX to create a local
area network (LAN). Wireless connection is possible after connecting the Gigaset SX686
WiMAX to the power supply (see page 28).
First connect just one PC to the Gigaset SX686 WiMAX, wired connection is recom-
mended. You can then carry out the general configuration.
Connecting a telephone, fax machine or answer machine
You can connect an analogue terminal, such as a telephone with cord, cordless tele-
phone, fax machine or answer machine, and operate them via the Internet in future
(Internet telephony/VoIP).
Connect the Gigaset SX686 WiMAX with the analogue phone as follows:
Depending on the connection plug on your analogue terminal, you may require an addi-
tional adapter (TAE socket on the RJ11 plug).
ì
If your analogue terminal has a TAE plug, first connect this to the adapter (connect
a telephone to the F-coded socket, a fax machine or answer machine to the N-coded
socket). Then connect the adapter plug to one of the Phone connections on the
Gigaset SX686 WiMAX.
ì
If necessary connect the telephone, fax machine or answer machine to the mains
power supply.
LAN cable
(yellow)
Quick Start Guide
ì
Connect one of the LAN
ports (LAN1 – LAN4,
yellow) on the Gigaset
SX686 WiMAX to the Eth-
ernet network card in
your PC. To do this, use
the LAN cable supplied
(CAT5, yellow).
ì
Insert the plug of the tel-
ephone into the Phone 1
or Phone 2 port on the
Gigaset SX686 WiMAX.
27