Led Indicators - Tenda Rx12 Pro Schnellinstalationsanleitung

LED indicators

After the router is powered on for about 40 seconds, the system completes startup. The
status of the LED indicator is shown in the following table.
LED indicator
Node Type
Status
Solid green
Blinking green
Primary node
Blinking red
slowly
Solid green
Solid orange
Solid red
Secondary Blinking green
Blinking green
slowly
Blinking red
slowly
07
Description
The system is starting up, or the router is already
connected to the internet
The router is pending for or performing WPS
negotiation or Mesh networking,
The router failed to connect to the internet.
Networking succeeds. Good connection quality.
Netv.orking succeeds. Fair connection quality
Networking succeeds. Poor connection quality
Networking by the WPS button or performing
WPS negotiation.
Waiting to connect to another node.
The router failed to connect the internet.
Jack, ports and buttons
0000
Jack/Port/
Description
Power jack.
POWER Please use the included power adapter to connect this jack to a
power source for power supply.
Reset button.
When the router isworking normal b',hold the button dov.'n using a
RST
needle-like item (such as a pin) for about 8 seconds, and then release
it when the LED indicator
WPS/Mesh button.
• WPS: When it is used as a WPS negotiation button, you Can
connect to the WiFi network of the router without entering the
WFi password.
Method: Short press the button (for about I second), and the
LED indicator blinks fast, Within 2 minutes, enable the WPS
function Of the OtherWPS-supported
WPS connection.
• Mesh; When it is used as a Mesh networking button, you can
extend your network With another device that supports the
Mesh function.
Method; press this button
indicator blinks green fast, Which indicates the device
searching for another device to form a network Within 2
minutes, press the MESH/WPS button ot another device tor I to
3 seconds to negotiate With this device.
10/100/1000 Mbps auto-negotiation WAN port
Used to connect to a rrod&n or the Ethernet jack using an Ethernet
cable for internet access.
After the router isconnected to
node, this WAN port is used as a LAN port.
10/100/1000 Mbps auto-negotiaüon LAN port.
Used to connect to computers, switches Otgarne machines, etc.
10/100/1000 Mbps auto-negotiation CAN/ PTV
It is a OANport by default. When the IPTV function is enabled, it can
PTV/3
only serve as an IPTV port to c:onnect to a set-top box.
blinks red fast. The router is reset.
device to establish a
tor abcrat 3 seconds, The LED
existing as a secondary