Cosatto Close to Me Bedienungsanleitung Seite 6

Fitting & Operation information:
Please refer to the instruction diagrams (p. 35 - 41):
Crib mode
1-
2-
3-
4-
5-
6-
7-
8-
9-
10-
11-
12-
13-
14-
15-
16-
17-
3
Preperation:
Securing the dropside (a).
Pull both top rails outwards (a).
Lift the crib section up until engaged in height position 1 (a) and secure the top rail
into position (b).
Open the leg section (a).
Place the mattress in the crib section (a).
Adjusting the crib section's height:
Press and hold the height adjustment buttons and adjust the crib section to
appropriate height.
The crib cannot be used in an inclined position and the height position on both
hinges should be matching.
Using the dropside:
Unzip the zips securing the dropside (a).
Press and hold the dropside release buttons on both sides (a) and lift the dropside
bar from its mounts (b).
Refitting is a reversal of this procedure.
DANGER! Always completely raise the dropside when not
attached to the adult's bed.
Using the castors:
Unlock:
Lock:
Bedside sleeper mode:
The bedside sleeper mode is only suitable for adult's bed, measured from the top of
the mattress, with the minimum height of 51 cm.
Lower the dropside (refer to step 8 & 9, a) and unlock the castors (refer to step 10, b).
In bedside sleeper mode, the crib section can be secured to the adult's bed by the
attachment straps in one of the three routing methods appropriate to the intended
adult's bed:
1/ Around the adult's bed mattress.
2/ Around the adult's bed frame.
3/ Around the side of the an adult's bed.
Adjust the crib section to suitable height (refer to step 6, a).
The top of the dropside must be at least 1 cm below the top of the adult's bed
mattress.
WARNING: To avoid hazards from the child's neck being
caught on the top rail on the side that is next to the adult
bed, the top rail must not be higher than the adult's bed
mattress.
Connect one of the attachment strap clip to one of the attachment strap buckle on
the crib (a).
Repeat on the other side of the crib.
Route both straps under the intended adult's bed mattress/ bed frame (b).
Route both straps over the intended adult's bed mattress/ bed frame (a).
Connect the remaining clips on both sides of the crib (b).