Grundig HiFi-Studio RPC 300 Bedienungsanleitung Seite 8

CB
On Off switch
Loudspeaker switches
Noise filter switch
O
Contour/Linear switch
(loudness control)
Volume control
O
Bass control
Treble control
Stereo balance
Frequency meter for FM programming
Tuning meter/ Field strength
on FM
Stereo indicator
Tuning button
Sensor fields for FM programming
(UI ... 1.17)with tuning controls.
For tuning in an FM station on the
main scale, sensor field
touched.
O
AFC button
Muting button for FM tuning
Mono Stereo button (release for
stereo)
Phono button for replay Of records
Tape button for replay from an
external tape or cassette
which must be connected
socket @ (TB).
Cassette button for replay from the
built-in cassette recorder
Wave band buttons
UKW FM band
LW Long wave band
Medium wave band
SW Short wave band
O
Earphone sockets
Aerial sockets
Y for AM aerial (LW, MW and SW)
for earth
for FM dipole (300 Q)
Connecting socket for external
or cassette recorder
Loudspeaker sockets for stereo
group I (R right-hand
L left-hand channel)
Loudspeaker sockets for stereo
group 2
Mains voltage setting indicator
(after changing the voltage setting,
the indicator must be removed
refitted in correct position
experienced technician).
Be sure to read the separate
books supplied
player and cassette
Mains Connection
This set has been designed
on AC and is preset for 220 V. For
operation on an other mains voltage, the
voltage setting
experienced
indications
The built-in
recorder are automatically
rect voltage.
Important Hint!
meter
The built-in
120 ... 127 V AC and the record player to
110 V. If these
external use, they must be adjusted
corresponding
operating instructions).
units into the Studio,
"U" must be
necessary to readjust
and 110 V respectively.
Aerials
In primary service areas good results can
be obtained
dipole eg: GRUNDIG
For the best possible
mend the use of an outside
recorder
especially when receiving
to the tape
casts. Remember
signal is required
transmission.
may not be suitable
regions or for long distance
unless it is mounted
above the roof
On the back
sockets for aerials and earth O. The two
sockets on the right are for connecting
300 Q FM dipole. When an outside
dipole is used AM reception
improved because
sockets are connected
shorting link mounted
sockets.
tape
If separate
or a communal
used, the shorting
channel,
otherwise inter-action
aerials will
If you are not sure of the signal conditions
in your area and remember
signal is essential
reception, we suggest you contact your
and dealer who will be pleased to advise you
by an as he will be familiar
for reception
instruction
for the built-in record
recorder.
to be operated
should be changed by an
technician according to the
given inside the unit.
record player and cassette
set to the cor-
cassette recorder is set to
units are removed for
to the
mains voltage (see separate
When refitting the
it is of course
them to 120 . 127 v
on FM with a simple room
FM strip dipole.
results we recom-
FM dipole
stereo broad-
10 times as much aerial
when receiving a stereo
Even an outside FM dipole
in mountainous
reception
as high as possible
of the house.
of the unit there are four flat
a
FM
may also be
the AM and FM aerial
together via a
between the two
outside aerials for FM and AM
aerial system is being
link must be removed
between the two
occur.
that a good
for optimum stereo
with the conditions
in your area.
Socket Y is intended for the connection
of an external AM aerial.
Socket is for earth connection.
Loudspeakers
For best possible reproduction
you use high quality high wattage
speakers with your Studio. The best
results will be obtained with 4 Q (min.
3.2 Q) loudspeakers (loudspeakers
impedance should not be used).
speakers with an impedance
may be used but the amount of power the
amplifier can deliver will be limited.
Two pairs of connecting sockets
mounted on the rear of the set (Ll and L2)
— O and O. It is possible to use both
sets of loudspeakers simultaneoue(v
separate rooms.
The set will deliver its maximum
(2 x 50 W music power, 2 x 30 W sine)
when the speaker sockets LI or L2 are
used separately.
When both LI and L2 are used
taneously the set will deliver 4 x 30 W
music power.
Always make sur that the right-hand
speaker unit is connected to the RH socket
and vice versa.
Note: Loudspeaker extension
available in 5 metres length (cable 375)
and 10 metres length (cable 376).
Headphones
2 sockets O conforming to DIN 45 327 are
provided on the right of the wave band
buttons. Headphones are particularly
suitable for the music lover who
listen undisturbed. Headphones
2000 Q impedance may be used. We re-
commend the GRUNDIG headphones
219 or 221.
Additional information for sets
Great Britain
Fit or have fitted a 13 A 3-pin plug and
fit the plug with a 3/5 A fuse. Connect
the brown wire of the mains
live pin, marked "L" or red or brown
and the blue wire to the neutral pin,
marked "N" or black or blue
account must either of the
connected to the earth pin, marked
or green or green!yellow.
Units sold in Great Britain
240 v.
we suggest
loud-
of lower
Loud-
of up to 16 Q
are
in
power
simul-
loud-
cables are
wishes to
of 5 to
215,
used in
lead to the
— on no
wires be
"E"
are set to
9