Westfalia 10 38 53 Bedienungsanleitung Seite 19

Setup
1. On the back of the receiver are two mounting holes (A8). These can be used to
mount the receiver to a wall or a similar object. Suitable screws and wall plugs are
included.
2. The receiver can also be places upright on a table or other surface with the fold-out
stand (A11). Carefully free the lower end of the stand from the battery compartment
and turn it out. Do not place loads on the receiver while it is on the stand, the stand
may break.
Operation
1. Use the ON/OFF switch to turn the receiver (A1) on.
2. Set the receiver to an optical (A4) or acoustic signal (A7) or both to indicate the
reception of a signal from a transmitter. Use the selector switch (A3).
☼
= Optical Signal
3. The LEDs on the signal source indicator (A6) indicate from which transmitter the
signal originated:
℡
=
Telephone Call
Each of the three transmitters will cause the receiver to emit a different acoustic
signal. This way, you can determine the source of the signal without being able to
see the receiver. The volume of the acoustic signal can be regulated with the
dial (A2).
Initial Setup and Operation
=
(
=
Acoustic Signal
Sound Indicator
14
☼
=
Both Signals
+
=
Door Bell