Electrical Connection - Rusta 62570013 Gebrauchsanweisung

MOUNTING THE AWNING ON THE WALL BRACKETS
• Unscrew the nuts and bolts in the wall brackets.
• Fasten the screw square beam in the wall brackets.
• Fasten the awning by tightening the bolts and nuts on the wall brackets.
• Tighten the nuts to ensure that the awning is secured on the wall mounts.
AWNING AS VIEWED FROM THE SIDE
NOTE! Remove securing straps after installation, otherwise the awning can
extend. Save the straps for later use when storing the awning. lncorrectly
positioning or installing the awning can result in serious personal injury or
property damage. Only install the awning yourself if you fully understand
the installation instructions and if your are certain that the wall on which it
will be mounted is suitable for this purpose. Contact a qualified installer for
assistance – for your own sake and for the sake of others.

ELECTRICAL CONNECTION

• The awning with remote central has an electric cord and plug. Connect the awning
to a grounded electrical outlet after it has been mounted on the wall brackets.
Electrical outlet Plug
NOTE! The awning must be connected to an electrical outlet with protection
class IP44 or higher, otherwise there is a risk of electric shock. For yours and
others safety, we recommend that a earth fault breaker is installed. lmproper
connection can cause serious damage to the remote control and/or motor.
Make sure that all connections are correct before the awning is used.
Wall
cross-
section
Brown
M
Blue
Yellow/Green
Wall
cross-
section
Locking plate
7