prologue R0085P-N Handbuch Seite 6

3. Press [ AL 1•2 ] again. "OFF" will appear. Press [ ▲ ] or [ ▼ ] to select
the type of alarm or "OFF".
- rd: radio
- bu: buzzer
- OFF: No alarm
4. Press [ AL 1•2 ]. Both "A2" (alarm 2) and the hours display will begin to
flash. Press or hold in [ ▲ ] or [ ▼ ] to set the hours.
5. Repeat steps 2 and 3 as listed above.
If you have selected the radio or buzzer alarm for alarm 1 and/or 2, either
"A1" and/or "A2" will be displayed depending on the corresponding alarm/s
you have chosen.
Switching the alarm off
1. When either alarm 1 or alarm 2 goes off, press [ A L 1•2 ] to switch the alarm off.
The alarm will go off again at the same time in 24 hours time.
2. If [ NAP▲ ] or [ RADIO/SL ] is pressed when the alarm goes off, the nap
function or the radio will be switched on and the alarm will be switched off.
Snooze function
Press [ ] to activate the snooze function when the alarm goes off.
The alarm will sound again after a short delay determined by the set snooze
time, refer to the Setting the time, 12- or 24-hour clock and snooze time
section above.
Note: If the second alarm is activated at the same time as the first alarm goes off
or if it is in snooze mode, the first alarm will be switched off and won't go off again
for another 24 hours. The second alarm will go off instead of the first alarm.
Display illumination
Press [ ] to change the strength of the display illumination, high/low.
Note: The display illumination level cannot be changed when the radio is on or
when the alarm is going off.
6