Maintenance And Disposal - Silverline 123557 Handbuch

GB
Before Use
• Carefully unpack and inspect your power drill. Fully familiarise yourself
with all features and functions of the tool.
• Ensure that all parts of your power drill are present and in good condition.
If any part is missing, or damaged, have such parts replaced before
attempting to use this tool.
Operating Instructions
Side handle
• The Side Handle (2) should always be used when drilling.
• Always hold the drill firmly using both hands.
On/off switch
• To start the drill, squeeze the On/Off Switch (4).
• To stop the drill, release the On/Off Switch.
Lock on button
• The drill is equipped with a Lock On Button (5). This allows the on/off
switch to be locked into the 'on' position for tasks that require extended
continuous running.
• To use the lock on function, depress the lock on button whilst squeezing
the on/off switch, the on/off switch can then be released and the drill
will continue to run.
• To stop the drill, squeeze then release the on/off switch.
Speed control
• The speed of the drill can be varied between 0 and 800rpm.
• The speed is adjusted by rotating the Speed Control Dial (6).
Reversing
• The direction of the drill can be changed using the Reverse Switch (3).
• To run the drill in an anti-clockwise direction, push the reverse switch to
the right.
• To run the drill in a clockwise direction, push the reverse switch
to the left.
• Do not attempt to move the reverse switch whilst the drill is running.
• Do not attempt to run the drill with the reverse switch in a mid position.
6

Maintenance and Disposal

Cleaning
• Disconnect the machine from the mains supply before cleaning.
• Keep your machine clean. Always clean dust and particles away, and
never allow ventilation holes to become blocked. Use a soft brush, or dry
cloth to clean the machine, if available blow through the ventilation holes
with clean, dry, compressed air.
Replacement brushes
• Over time, the carbon brushes in the motor will wear away. This wear
process will be accelerated if the machine is used in dusty environments,
or if the machine is overloaded.
• If the brushes have become excessively worn; motor performance may
decrease, the machine may fail to start, or excessive sparking may be
observed.
• If you suspect that the brushes may be worn, have them replaced at an
authorised service centre.
Disposal
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste.
• Contact your local waste disposal authority for information on the proper
way to dispose of power tools.