PIKA GSM Interno Montage- Und Bedienungsanleitung Seite 26

7. OPERATION
Save your telephone-number (done only once)
The operation of the stove is controlled by SMS commands. These
consist of the reception code you selected (described earlier) and a
command. After correct installation of the GSM set you must save a
valid telephone number on the device. (This is not possible when you
suppress your telephone number.)
In this case the TEL command follows the reception code.
Example-SMS
The device will save the telephone
1234 TEL
number and send a confirmation
(Note the SPACE
message back (MOBILE NUMBER „your
between code and
number" OK).
command)
Now you are able to set the stove to another operating mode by using
SMS-commands.
Note
You are also able to save a new number by sending a TEL code
again.
You also can send commands without registering a telephone number
using simply the reception code. In this case you will get back a
message „Please save TEL. number" in your answer-SMS.
Caution:
If no telephone number is stored at the device you will not receive
any message in case of errors.
The simplest command is switching ON and OFF:
Example SMS:
1234 ON
Device ON with presetting (operating
mode and setting maintained from
(Note the SPACE
previous operation)
between reception and
command code)
1234 OFF Device OFF
Command Input and Responses from Stove Software
Version 1.12/Touchscreen Software Version 1.22
(case insensitivity)
Start in the Manual Mode by specifying the heat output without
heating time:
Please note the space between the numerical
for example:
code and specification! The response (SMS reply)
1234 M70
reads: Manual Mode 70%
Start in the Automatic Mode by specifying the heat output with
heating times preassigned (If no heating times are stored , the stove
remains in standby)
for example:
The response (SMS reply) reads:
Automatic Mode 70 %, Heating Times Active
1234 A70
Start in the Comfort Mode by specifying the target room temperature
without heating times:
for example:
The response (SMS reply) reads:
Comfort Mode 22°C
1234 C22
Start in the Comfort Mode and specify the target room temperature
with heating times preassigned:
for example:
The response (SMS reply) reads:
Comfort Mode 22°C, Heating Times Active
1234 CT22
Switching off the pellet burner:
for example:
The response (SMS reply) reads:
STOVE OFF
1234 OFF
Frost Protection
It is possible to activate and deactivate the function frost protection
here:
for example:
The response (SMS reply) reads:
FROST PROTECTION ON
1234 FON
for example:
The response (SMS reply) reads:
FROST PROTECTION OFF
1234 FOFF
Operating parameter queries
Various set parameters are sent here (status, day heating times, actual
room temperature, etc.):
The response (SMS reply) reads:
Stove ON
for example:
AUTOMATIC MODE 65%
1234 ?
BURN OFF
HT1 ...
The current status, for example, could be: inactive, ignition, manual
mode, cleaning phase, etc.
HT1: Heating time 1 (if no heating time is set, 00:00 is displayed)
HT2: Heating time 2 (if no heating time is set, 00:00 is displayed)
RT: Actual room temperature (only with connected room sensor)