Activation On Touchscreen - PIKA GSM Interno Montage- Und Bedienungsanleitung

Inserting optional wireless room sensor
Plug together the cable of the optional wireless room sensor with the
cable connection. Secure all cables and connectors with cable ties on
the cable channel.
Note
Protect all cables inside the stove from the heat! Improper
installation can damage your stove and void your warranty.
5. EXPLANATIONS
To activate the GSM function, the GSM setting must be set to ON
under the SETUP / Settings menu. You must also set the four-digit
reception code.
You can select this code free. (On the following pages the numbers
1234 are used by way of example to make the instructions
comprehensible.)
The reception code is used to prevent unauthorised access to your
GSM Modem.
According to a successfully command code a confirmation message
will be sent. This is not possible when you suppress your telephone
number!
Important
To get answer messages enough credits on the SIM-card are
necessary.
Note:
When the GSM has been properly connected to the stove's interface
and the plug has been inserted into the power socket, the LED display
on the modem will flash orange at brief intervals. If there is adequate
reception, the orange display will flash at long intervals.
Push back the stove into the wall. Secure the stove from the bottom to
prevent accidental sliding out.
Open the decorative door.
Connect the stove with the power plug and mount the parts in reverse
order.
Your stove is ready for use again.

6. ACTIVATION ON TOUCHSCREEN

1. Select „GSM" from the Setup menu.
Setup
Child Lock
Cross Fan
GSM
2. Then press the button labelled „PIN Code".
GSM
GSM
PIN-Code
3. Now enter a four digit PIN code (numerical code) and confirm your
entry by pressing the enter button.
PIN-Code
After a successful initializing, the GSM function is fully activated and
operational.
#5
Su 15.03.2012 15:55
Su 15.03.2015 15:55
OFF
1234
Su 15.03.2012 15:55
PIN-Code
|
1234
|25
24
#2