Chasing Hydro 3 Benutzerhandbuch Seite 4

Power adapter
EN
�
1. Power adapter
2. AC power cord
Charging and Operation
Charging
1
1. Please charge the Cleaner with the official standard power adapter of CHASING.
2. Dry the water on the charging port of the Cleaner before charging.
3. Align the charger with the anti-misconnection design of the charging port and insert it correctly.
4. If the power adapter indicator is in red, the charging is in progress; if in green, the charging is
completed. After charging, unplug the adapter in time.
5. Reinstall the rubber plug after charging to prevent water from entering.
Precautions
1. As the long-term storage will accelerate the self-discharge and passivation of active
substances, it is recommended to fully charge and discharge the Cleaner every three months
to reduce the negative impact of long-term storage, and then restore its original performance.
2. The lithium battery of this product is not replaceable, so it should be recycled by a qualified
battery recycling station, rather than being discarded in the trash can.
3. Do not place the device vertically for charging to prevent water from entering the charging port.
4. Do not charge indoors.
04
�
�
5. Battery protection:
Do not run out SOC < 5%
of battery Please charge it
Operation and Application
2
1. Power ON: Slide the switch button to the "ON" mark to turn on the Cleaner, and the indicator
will be steady on.
2. Power OFF: Slide the switch button to the "OFF" mark to turn off the Cleaner, and the indicator
will be off.
3. After power-on, put the Cleaner into the pool, and get it to start cleaning after reaching the
pool floor.
Keep SOC at Operating
50%-70% when idle. temperature: 5-35℃
EN
05