HOMCOM C30-044V01 Bedienungsanleitung Seite 3

Operation of the stand with plastic front adaptors
1. Loose the screws on the top so that the
position of adaptors can be adjusted.
2. Roll the stand and make sure your
motorcycle front wheel is in the middle of
the frame.
3. Rise the stand with circled handle and
adjust the adaptors to make the front
adaptors pins get into the bottom holes of
the front fork. Then tighten the screws.
4. With the adaptors securely supporting the
bottom of the motorcycle front fork, lower
the stand frame onto the ground in order to
lift the motorcycle front wheel up.
Important
Always keep this stand away from children.
Check the stand is in good condition before using it.
3
Pointer
upright!