HOMCOM C30-044V01 Bedienungsanleitung Seite 2

EN
Accessories
① 1PC x Front handle frame (smaller one)
② 2PCS x Front frame for wheels
③ 4PCS x Wheels
④ 2SETS x M8 Screw, washer and locknut set
⑤ 4PCS x Clamping piece
⑥ 2SETS x M10 Screw, washer and locknut set
⑦ 2PCS Screw with plastic topper
⑧ 1PAIR V-shaped front adaptor
⑨ 1PAIR Plastic front adaptor
Assembly instructions
Step 1: Assemble the wheels ③ on both sides of the frame ② and then Insert both pieces
of frames with wheels in to main frame①.
Step 2: Push M8 screws through the holes of clamping pieces ⑤ and frame, make sure
that the connecting part are covered with clamping pieces on both sides. Then add
washers and use tools to tighten with the locknuts.
Step 3: Loose the both sides screws ⑨ on the top of the frame with wheels, insert the
correct adaptors (V-shaped ⑧ or plastic front adaptors ⑨) which can fit your
motorcycle.
Operation of the stand with V-shaped front adaptors
1. Loose the screws on the top so that the
position of adaptors can be adjusted.
2. Roll the stand and make sure your
motorcycle front wheel is in the middle of
the frame.
3. Rise the stand with circled handle and
adjust the adaptors to make the front
adaptors hold the bottom front fork well.
Then tighten the screws.
4. With the adaptors securely supporting the
bottom of the motorcycle front fork, lower
the stand frame onto the ground in order to
lift the motorcycle front wheel up.
Motorcycle Front Stand
2