Interval; Start - JRG CleanLine Filter Bedienungsanleitung

5.2. INTERVAL

„INTERVAL" defines the time interval between
backwashes.
"INTERVAL" allows you to change the factory
setting (60 d). If you press the "INTERVAL" key,
the LEDs will flash one at a time. After select-
ing the desired value, the setting is saved after
3 seconds.
The following settings are available:
7 d = 7 days, 1 backwash
30 d = 30 days, 1 backwash
60 d = 60 days, 2 backwashes
(factory setting)

5.3. START

„START" defines the start time of the first back-
wash after commissioning the device.
"START" allows you to change the factory set-
ting (6 h). If you press the "START" key, the LEDs
will flash one at a time. After selecting the de-
sired value, the setting is saved after 3 seconds.
The following settings are available:
6 h = 6 hours (factory setting)
12 h = 12 hours
24 h = 24 hours
E
59