ALZA Wireless One-to-One Temperature Control Benutzerhandbuch Seite 7

Parameter setting
In the shutdown state, long press the
setting interface. At this time, press the
parameters to be set, rotate the outer frame to adjust the parameters of each item, and
press the button to save and exit.
Paramter
Paramter name
item
Temperature
1
compensation
2 Switch deviation setting
The shutdown antifreeze
3
function starts and stops
4 Rest day selection
Set the upper limit of the
5
temperature
6 Restore factory settings
Installation method
Install an expansion screw sleeve with a spacing of 59mm on the wall.
Use a screwdriver to separate the upper cover and the lower cover, pursuant to the wire
direction, pass the wire through the back cover to the wiring duct, and leave about 20cm
long as per the actual situation.
button for 5 seconds to enter the parameter
button to cycle through the selection of the
Default value
The temperature compensation
0
The temperature difference
1
start-up range is 0.5-10°C
OFF: Turn off the antifreeze
ON function ON: Turn on anti-
2
Set the upper temperature range
60°C
Long press
display
7
Function meaning
range: -9.9 – 9.9°C
freezing function
0: Turn off programming
1: Take a day off
2: Two-day weekend
3. No rest
from 15-95°C
for 3 seconds,
to restore
factory settings.