SimonsVoss PinCode-Terminal Kurzanleitung Seite 37

PinCode-Terminal
6. Insert the new batteries with the positive terminal facing upwards
7. Carefully hook the battery clips back into the circuit board.
8. Replace the cover.
9. Press the cover against the base plate and screw the cover back in
9
Reset battery
ü
warning
1. Press 0 for more than two seconds to activate programming mode.
2. Enter 99.
3. Enter 99999.
4. Enter the Master PIN.
9
8 Signalling
Signal
key confirmation signal
OK
Wrong locking device or
locking device not reached
EN
(Murata, Panasonic or Varta CR2032 (3V) batteries).
place.
Batteries are replaced.
Batteries are replaced.
9 PIN code terminal beeps and flashes orange once.
Battery warning is reset.
Description
Beep and flash green.
Beep and flash green twice. 1 second
Beeps and flashes green
once and then red twice.
8. Signalling
Duration
Split seconds
Seconds
37 / 144