SimonsVoss PinCode-Terminal Kurzanleitung Seite 35

PinCode-Terminal
warning level
2 (very weak)
NOTE
Battery warning disables programming mode
Programming mode cannot be used during an active battery warning.
All functions for which programming mode must be entered are
blocked.
1. Replace the battery (see
2. Reset the battery warning.
9
7.2 Battery replacement
ü
1. Unscrew the screws holding the cover in place.
2. Remove the cover.
EN
Effect
Opening is delayed 10 seconds.

During these ten seconds, the PIN code terminal beeps

and flashes yellow.
After the delay, the locking device engages.

Change the batteries now at the latest. Otherwise, the PIN
code terminal will fail after a short time.
Programming mode is accessible again.
Screwdriver present (Torx TX6).
Battery replacement [
7. Battery management
}
35] ).
35 / 144