Micro Matic PREMIUMPLUS100 Bedienungsanleitung Seite 3

a CO /N leak is found, leave
2 2
the area and arrange for
immediate ventilation.
• It is vital that you are
aware of and understand
the properties and risks,
so that you can take the
appropriate steps in case of
an emergency. If you are in
doubt, please contact your
gas supplier.
Instruction how to mount
the regulator
The reducers are exclusively
intended for the use with CO
N - or mixed gas.
2
The gases must accord with the
requirements of the beverage
industry and marked with the
symbol E290 for CO2.
1. The gas cylinder must be
protected against toppling
down.
2. Before connecting the
reducer, open the gas
cylinder valve shortly for
removing possibly existing
dirt particles and ensuring
the gas discharge.
3. Control if the seal on the inlet
connection of the reducer is
mounted and if the sealing
surface of the gas cylinder
valve is not damaged.
4. 4With a wrench the reducer
must be mounted on the
gas cylinder valve in a way
that the outlet of the reducer
is adjusted downward.
Recommended mounting
torque: 10Nm. Important, do
not overtighten!
5. Turn the adjusting
screw of the reducer
counterclockwise as far as
it will go (zero setting) and
close the shut off valve (if
existing).
MICRO-MATIC.COM
-,
2
|
3