Soltop Duraklick HSS-System Benutzerhandbuch Seite 11

Instructions for use
3. Attaching the runner
There are two different runners for the HSS system: the
standard runner, which can only be attached at an end
stop, and the openable runner, which can be attached
anywhere on the guide rail. Instructions for use of these
two runners are given below.
Attaching the runner (standard)
Place the HSS runner on the rail at the end stop. Pull the
locking pin downwards and attach the runner. Ensure the
runner is firmly seated on the aluminium guide rail and
slides freely back and forth.
Attaching the openable runner
Thanks to its opening mechanism, this runner does not
need to be attached at an end stop, but can be attached
and removed at any point on the rail.
To do so, pull the locking pin downwards
the runner and open the runner by squeezing the sides

together – the two parts of the runner will then move
apart.
Now place the open runner on the rail and release it. En-
sure the runner is firmly seated on the aluminium guide rail
and slides freely back and forth.
4. Attaching the fall arrester
The safety harness and rail are connected to each other
via the fall arrester (shock absorber or rope adjuster),
which is attached to the safety harness and the connec-
tion eyelet of the runner. The snap hook is attached to the
connection eyelet of the runner.
The self-retracting webbing must always be taught. En-
sure that the self-retracting webbing does not get caught
on obstacles, otherwise there is a risk of a pendulum fall!
When using a restraint system with rope
!
adjuster, the connecting element must be
adjusted such that a fall is impossible. In
case of non-compliance, SOLTOP does not
accept
ATTENTION!

(black ball) on
Pull locking pin
downwards


Pull locking pin
downwards
Push the runner
together
11