Xoop Lighting NANOBAR FC Bedienungsanleitung Seite 20

20
AUTO MODE
Here you can select the desired automatic program and set its speed.
1. Press,,ENTER'' button and then „UP'' or „DOWN'' button until „AUTO'' is showed
2. Press ,,ENTER'' button again and then „UP'' or „DOWN'' button to choose the
automatic programs or the speed
3. SPEED: Sets the speed from slow to fast
4. AUTO: Choose one oft he automatic programs
MANUAL MODE
In this menu, you can adjust the value of static color and strobe speed as you like.
1. Press „ENTER'' button and then „UP'' or „DOWN'' button until „MANUAL MODE'' is
showed
2. Press „ENTER'' button again and choose with „UP'' or „DOWN'' button one of the
following options
3. RED: Adjust the brightness of the red LED's
4. GREEN: Adjust the brightness of the green LED's
5. BLUE: Adjust the brightness oft he blue LED's
6. STROBE: Activates strobe and adjust it's speed
7. COLOR: One of the 10 static colors can be set
SET UP
In this menu you can adjust various settings.
1. Press „ENTER'' button and then „UP'' or „DOWN'' button until „SET UP'' is showed
2. Press „ENTER'' button again and select by „UP'' or „DOWN'' button from the following
options
3. DIMMER ALL: Sets the general brightness
4. BALANCE: Sets the brightness ratio between red, green and blue LED's
5. KEY LOCK: (De)activates the key lock function. Password is: „DOWN''+ „UP'' +
„DOWN''+ „UP''
6. REMOTE: (De)activates the remote control function
7. DISPLAY: Select „ON'' to let the display be on all the time, select „30S" to turn it off
after 30s without use
8. RESET: Resets all values oft he system
9. REFRESH RATE: Adjust the refresh rate
10. DIMMING DELAY: Adjust the speed of dimming delay
11. MAX TEMP: Adjust the maximum temperature