Perry Electric 1TX RX01/P Handbuch Seite 9

2.2 - NEW DEVICE
When turned on, the receiver has only the
N.B.: There may be a weak lighted signal on the
2.3 - TEMPORARILY FORCING THE STATE OF THE CONTROL OUTPUT (for example, to test the system)
A) TRANSMITTER NOT YET COUPLED OR NOT ACTIVE
!
Hold down the " " key until there is a brief audible signal, then release it: the control is activated and the corresponding
steady on (fig.3).
The control will remain activated for 5 minutes, at the end of which, an audible signal will continue for
its imminent deactivation (fig.4): if you wish to keep it active, press the "
otherwise, when the signal ceases, the control will be deactivated.
Cancelling the temporary forcing of the control
!
Briefly press the " Reset key "
cancelled (fig.5).
N.B.: Before performing this operation, consult chapter 2.9 "
B) TRANSMITTER COUPLED AND HEAT REGULATION ACTIVE
The above-indicated operations can also be performed, using the same methods, during normal heat regulation operation; in this case,
the temporary forced control will cause the transmitter to be excluded and the reversal of the command status: if active, it will be
deactivated and vice versa. During the forced state, the "
ON LED lit.
lower LED of the
Fig. 3
; when released the temporary forced control is
Reset
" key
VMETER , due to the presence of radio interference.
" key again while the audible signal is sounding;
5 minutes
"
is not functional.
LED is
5 seconds to alert the operator of
5 s
Fig. 4
RESET
Fig. 5
E
N
9