On The Transmitter; Normal Operation - Perry Electric 1Tx Rx01/P Handbuch

2.5 - CHECKING THE INTENSITY OF THE RECEIVED SIGNAL - VMETER

ON THE TRANSMITTER

!
Activate the "check the intensity of the radio signal mode",
ON THE RECEIVER
!
The intermittent " " LED
transmitter.
!
The 3 LEDs on the VMETER
the intensity of the radio signal received, as illustrated in the figures to
the side.
N.B.: Verification mode on the transmitter automatically terminates 3
minutes after activation.
If you wish to interrupt the verification, deactivate
transmitter, as explained in the instruction manual.
ATTENTION: even in

"normal operation"

stored):
!
Press the " " key for about 2 seconds, then let go: the
for 5 seconds.
2.6 - NORMAL OPERATION
The transmitter controls heat regulation and sends commands and control signals to the receiver, which
implements them on the burner or solenoid valve. The operational safety of the control is assured by the
double sending of commands, a short time apart, and by an effective self-diagnostic system.
!
ON LED: lit
!
" " LED: lit with command activated, off with command deactivated
!
VMETER LED : brief lighting of 1, 2 or all the
In the event the transmitter is set to
in this state until it receives a new instruction from the transmitter.
indicates the coupling condition of the
, together with the audible signal
"Verify" mode
it is possible to check the intensity of the last radio signal received (the last signal is always
LEDs
LEDs at each radio signal received
OFF (system excluded), the receiver deactivates the load and remains
as explained in the specific chapter of the transmitter manual.
SIGNAL INTENSITY
LOW
, indicate
ON
on the
on the VMETER will show the intensity of the last signal received
MEDIUM HIGH
ON ON
Fig. 9
Fig. 10
ON
Command Command
activated deactivated
E
N
11