Instructions For The Installer; Installation Example - Perry Electric 1Tx Rx01/P Handbuch

1 - INSTRUCTIONS FOR THE INSTALLER

1.1 - INSTRUCTIONS AND REQUIREMENTS FOR INSTALLING THE RECEIVER
Install the receiver at a height that allows the antenna to stick up above any nearby metal container (boiler, expansion tanks, metal
E
cabinets); avoid positioning the antenna near cables and electrical panels (fig. 1.i - fig. 2.i)
G
N
B
Cabinets, walls and slabs containing metal can limit the operation of the product
This system is incompatible with radio products a working on the same frequency using permanent
emission mode.
Important: installation and electrical connections of devices and appliances must be implemented only by a qualified
electrician and in compliance with current regulations. The manufacturer declines any liability in connection with the use of
products subject to special environmental and/or installation standards. The examples shown in this document are of principle.
Instructions relative to the structure of realizable systems and the assignment of areas to individual timer-thermostats or
thermostats are shown in the technical documentation for the transmitter devices (chronothermostats and/or thermostats).
DIMENSIONS
ON
RESET
133
4

INSTALLATION EXAMPLE

Chronothermostat
25
.
INSTALLATION
Receiver
Burner
Fig. 1.i
OK
ON
RESET
ON
RESET
Fig. 2.i