Perry Electric 1TX RX01/P Handbuch Seite 12

2.7 - SIGNALING A TRANSMITTER MALFUNCTION
The receiver reports two types of transmitter anomalies:
E !
Failure to receive a radio signal for more than 30 minutes
!
N Transmitter battery almost dead
In both cases, the signal is given by the intermittent, simultaneous lighting of the
channel LEDs .
ATTENTION: in the case of the lack of a radio signal, the control of the load is also
deactivated (Burner control deactivated).
2.8 - DELETING A TRANSMITTER COUPLING
It is possible to delete a transmitter coupling even if it is not able to transmit the Test signal.
!
Press and hold the "
The transmitter coupling is erased from the memory of the receiver and the channel is free.
ATTENTION: in the event the key is released before the
beginning of the long beep, the operation is automatically
cancelled and the command output is set to "Temporary
Forced" (see paragraph 2.3).
Press " RESET Key " to return to normal operation.
2.9 - RESET
The RESET command on the receiver cancels all the data stored in the device
except for the transmitter coupling.
!
Briefly press the RESET key
together with a beep and the
12
(even in a state of malfunction)
" key until the end of the sequence of beeps shown in the figure; then release it.
Fig. 12
: when it is released, all the
ON LED will be steady lit.
ON and
FROM THE RECEIVER
6 s 4 s
When the key is released during this period of
time, the operation is cancelled
Fig. 13
LEDs will light
RESET
ON
Fig. 11
4
s
1 s 1 s 1 s
ON
2
s