Contest VRDM-CONTROL Benutzerhandbuch Seite 10

English
4.1 - Sceen 1 : Main menu
Press MODE to access this screen.
This menu gives access to the various VRDM-CONTROL functions.
Each function is described in detail below.
To return to the home screen, press MODE.
4.2 - Screen 2 : RDM menu
This menu gives access to the various settings for each fixture connected to the DMX line..
VRDM-CONTROL checks the list of connected devices.
At the end of the check you'll see a list of devices.
- Use the UP and DOWN keys to select a device. The designated device flashes to identify it in the projector chain.
- Press ENTER to access the various settings for the selected fixture.
Note: Each type of projector has its own specific menu. Refer to your projector's documentation to find out which
functions are specific to it.
- Use the UP and DOWN keys to select a function.
- Use the LEFT and RIGHT keys to access the sub-functions.
- Press ENTER to activate modification.
- Use UP and DOWN keys to modify values.
- Press ENTER to validate.
- Press MODE to return to return back.
Note: when using a DMX splitter as part of an installation, it is imperative that the hardware is RDM-compatible, so
that Versatile devices can be recognized by VRDM-Control.
The VRDM-Split H11546 will meet this need.
4.3 - Screen 3 : DMX Check Values menu
This mode displays the values of incoming DMX channels when a device emitting a DMX signal is connected
as input.
Note: In order to perform this operation, a male/male XLR plug must be used at the VRDM-CONTROL input.
- The display shows 103 lines of 5 channels.
- Channels with values of 000 are displayed in white, others in red.
- Use the UP and DOWN keys to scroll through the lines and view the different channels.
4.4 - Screen 4 : FW Updater menu
This menu is used to update a device's firmware.
- Connect the VRDM-Control to the PC using the USB-C cable supplied.
- Switch on the VRDM-Control, a page will open on the PC as the box is recognized as a USB stick.
- Drag the update files to the SD card directory open on the PC.
- Go to FW Updater mode.
- Connect the VRDM-CONTROL to the fixture using a DMX cable.
- Select the file to be sent to the projector.
- Select the transfer speed :
- Fast : Standard speed to be used in most cases.
- Normal : Speed used when the update fails or if you're updating several devices. However, we strongly
advise you to update only one projector at a time.
- Press ENTER to confirm. The display shows START/RETURN.
- Select RETURN: In case of error, nothing happens.
- Select START to start the update.
- Press ENTER to confirm: the display shows «Find Device» to indicate that communication with the projector is
being prepared. Once the device is ready, the update starts automatically.
Page 10
VRDM-CONTROL - Contest Architectural RDM updater controller