Basic Operation - Velleman CS10MD2 Bedienungsanleitung

6. Battery
1. Open the battery compartment using an appropriate screwdriver.
2. Insert one 9 V alkaline battery according to the correct polarity.
3. Close the battery compartment.
Warning: Do not puncture batteries or throw them in fire as
they may explode. Do not attempt to recharge non-
rechargeable batteries (alkaline). Dispose of batteries in
accordance with local regulations. Keep batteries away from
children.
7. Operation

7.1 Basic Operation

1. Hold the device by the handle and switch it on. Wait for the device to
finish the initialisation. The device is ready-for-use when the green
LED burns.
2. Sweep the device over the body: it will beep and the alert LED will
burn when a metal object is found.
3. Switch off after use.
7.2 Functions
Audio Tone Discrimination
The device beeps quietly when it detects a small metal object; it will beep
loudly when a larger metal object is detected.
Sensitivity
Insert the tip of a small screwdriver into the SENS ADJ. hole. To set the
ideal sensitivity rate, slowly rotate clockwise to increase or anti-clockwise to
decrease the sensitivity, until both the audio and visual alarms signal
continuously. Then slightly turn anti-clockwise.
Reset
Press the reset knob to reset the device.
Low-Battery Indication/Earphones
Replace the battery if the device beeps continuously and the LEDs do not
burn.
Using earphones will help you hearing the audible alarm in noisy
environments. Also, the batteries will last longer.
V. 01 – 20/09/2016
CS10MD2
5 ©Velleman nv