Blind Rivet Nut Setting Tool; Technical Data; Threaded Mandrels And Nosepieces Rivet Nuts Per Charge; Safety Instructions - Atlas Riv 790 Betriebsanleitung

2.3. Technical Data

Weight: 2,3 kg (with battery, without
accessories container)
Max. stroke: 5,5 mm
Operating voltage: 12 V DC
Traction power: 13.000 N
L
Noise emission:
PA
Vibrations: < 2,5 m/s
2.4. Threaded Mandrels and Nosepieces
Rivet Nuts per Charge
Blind rivet Material Rivet nuts
nut inner per
thread charge
M3 Alu 600
Steel 550
M4 Alu 520
Steel 480
M5 Alu 480
Steel 400
M6 Alu 400
Steel 300
M8 Alu 340
Steel 180
M10 Alu 300

2.5. Safety instructions

Blind rivet nut setting tool RIV 790
Caution :
Following safety rules must be followed
for adequate protection against electrical shock,
injuries or re hazards:
•
The tool should be used exclusively to set blind
rivet nuts.
•
Do not overload the tool; Work within the pre-
scribed work capacity.
•
Do not expose the tool to humidity or rain, do
not operate the tool close to in ammable sub-
stances or gases. Risk of explosion!
•
Ensure that the battery is properly secured in
the tool handgrip.
•
Remove the battery when the tool is not in use
and for repair/servicing operations.
•
Do not use the tool as a hammer.
•
When not in use, keep the tool in a dry closed
room, out of reach of children.
76,5 dB
2
Part number
Threaded Nosepiece
Mandrel
1551700 1552300
1551800 1552400
1551900 1552500
1552000 1552600
1552100 1552700
1552200 1552800
•
When working with the tool, always carry pro-
tection goggles. Personal protection like clothes,
gloves, safety helmet, non slipping shoes, ear
protectors and protection against fall are highly
recommended.
•
T e h a r i n i e l s t o f t r e h e n i g
structed. Do not introduce anything into them.
•
When depositing the tool, make sure that it
a c n n o f t l l a d o w . n
•
Use only genuine spare parts for repair.
•
Repair work must be carried out by skilled per-
sonal. In case of doubt, always send back the
tool to the manufacturer.

2.6. Starting Procedure

Before starting read and follow operating
manual carefully!
2.6.1. Adjustment of threaded
x
mandrel length

(drawing 2)

– By turning the nosepiece 2 adjust the threaded
mandrel length x to the blind rivet nut length.
– In case of closed end rivet nuts (drawing 2; 4)
use full length of thread.
– Lock nosepiece 2 with lock nut 3 against shifting.
2.6.2. Adjustment of stroke
– The stroke y depends on the blind rivet unit size
(M3 – M10) and the grip range
Recommended value for stroke y:
Stroke y (in mm)
Thread
size min
M3 1
1
M4
1,5
M5
M6 2,5
M8 2,5
3
M10
– The stroke y is adjusted by screwing in or out
the adjustment nut 4.
e n h s o u d l n t o b e o - b
y
(drawing 2)
z (drawing 4).
max
2
2
2,5
3,5
3,5
4
11