Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Safety precautions
This product complies with the requirements of the following European Community Directives:
2004/108/EG (Electromagnetic Compatibility) and 2006/95/EG (Low Voltage) as amended by
2004/22/EG (CE-Marking).
To ensure safe operation of the equipment and eliminate the danger of serious injury due to short-
circuits (arcing), the following safety precautions must be observed.
Damages resulting from failure to observe these safety precautions are exempt from any legal
claims whatever.
*
Do not use this instrument for high-energy industrial installation measurement.
*
Do not place the equipment on damp or wet surfaces.
*
Replace a defective fuse only with a fuse of the original rating. Never short-circuit fuse or
fuse holding.
*
Check test leads and probes for faulty insulation or bare wires before connection to the
equipment.
*
To avoid electric shock, do not operate this product in wet or damp conditions. Conduct
measuring works only in dry clothing and rubber shoes, i. e. on isolating mats.
*
Never touch the tips of the test leads or probe.
*
Comply with the warning labels and other info on the equipment.
*
The measurement instrument is not to be to operated unattended.
*
Do not subject the equipment to direct sunlight or extreme temperatures, humidity or
dampness.
*
Do not subject the equipment to shocks or strong vibrations.
*
Do not operate the equipment near strong magnetic fields (motors, transformers etc.).
*
Keep hot soldering irons or guns away from the equipment.
*
Allow the equipment to stabilize at room temperature before taking up measurement
(important for exact measurements).
*
Use caution when working with voltages above 35V DC or 25V AC. These Voltages pose
shock hazard.
*
Periodically wipe the cabinet with a damp cloth and mid detergent. Do not use abrasives or
solvents.
*
The instrument is suitable for indoor use only
*
Do not operate the meter before the cabinet has been closed and screwed safely as
terminal can carry voltage.
*
Do not store the meter in a place of explosive, inflammable substances.
*
Do not modify the equipment in any way
*
Do not place the equipment face-down on any table or work bench to prevent damaging the
controls at the front.
*
Opening the equipment and service- and repair work must only be performed by qualified
service personnel
*
-Measuring instruments don't belong to children hands.-
1.1. Cleaning the cabinet
Prior to cleaning the cabinet, withdraw the mains plug from the power outlet.
Clean only with a damp, soft cloth and a commercially available mild household cleanser. Ensure
that no water gets inside the equipment to prevent possible shorts and damage to the equipment.
NOTE:
Laboratory Power Supplies are not designed for charging batteries. Any use of this type can
cause serious damage to the device, which are exempt from any legal claims whatever.
-5-
Werbung
