Technical Support - Labor Pro Multiwave B280L Gebrauchsanweisung Und Garantie

ENGLISH - TRANSLATION OF THE ORIGINAL INSTRUCTIONS
5. To change the temperature, press
the + button (3) to increase it or - (4)
to decrease
corresponds to a change of 5°C.
6. Adjust the amplitude of the wave
using the knob (6) at the end of the
lower part of the appliance.
7. Brush the hair. Select a lock and
insert it between the bars (7) starting
from the base of the hair. Apply light
pressure, leave for a few seconds
and then repeat the movement to
the ends and all over the hair.
8. The appliance
automatically
switching on. To resume work, switch
the appliance on as indicated in
step 2.
Problem
The display does not
light up and/or the
appliance does not
heat up.
The cord or the
appliance makes
abnormal noises or
sparks.
The display does not
stop flashing.
Appliance has
switched off after 60
minutes after switching
on.
If the problem is not solved, contact your dealer or Labor Pro Technical Service
Centre.
it. Each press
switches off
60 minutes after
TROUBLESHOOTING
Possible reason
Fault in the circuit
board or heating
The appliance or
the power cord is
damaged.
The appliance is
heating up but does
not reach the set
temperature.
The energy-saving
function has been
activated.
CLEANING AND GENERAL
MAINTENANCE
Before carrying out any cleaning or
maintenance work, disconnect the
mains plug from the power supply and
wait until the appliance has cooled
down. Use a dry cloth or one slightly
moistened with water for cleaning.
Never immerse the device in water or
other liquids. Do not use chemicals for
cleaning.

TECHNICAL SUPPORT

For repairs or to purchase spare
parts, contact your dealer. If this
is not possible, contact the Labor
Pro Assistence Centre by email at:
assistenza@laborprosrl.com
element.
Action
Request an inspection
or repair at the place
of purchase.
Switch the appliance
on again.
EN
9