Setting The Temperature Unit; Alarm Setting; Max/Min Temperature And Humidity Record; Channel Select - Optus Easy Bedienungsanleitung

9. SETTING THE TEMPERATURE UNIT

Station:
In normal mode, press
Sensor:
Please press the F button on the sensor with a thin object (e.g. the end of a
paper clip)

10. ALARM SETTING

In normal mode, press
When check the alarm time, Press
the alarm. When the alarm turns on, the alarm symbol
display.
When enter the alarm mode, press and hold the
onds to enter the alarm setting mode. Digits to be set are flashing. Press
or button to change the value. Press
the next setting. Settings order: Hour> Minute> Snooze time (05-60min). Final-
ly press the button to save the settings and exit the Alarm setting mode.
• When the alarm sounds (will sound for 2 minutes), press the
button to activate the snooze function. (Zzz is flashing). The alarm sounds
again after the snooze time you set up (e.g., 5 minutes).
• When the alarm sounds, press any other key to stop the alarm until the set
alarm time is reached again.

11. MAX/MIN TEMPERATURE AND HUMIDITY RECORD

In normal mode, press the
and humidity record. The MAX and MIN symbols (10 and 24) are displayed
accordingly. The setting order is MAX temperature and humidity > MIN tem-
perature and humidity > Current temperature and humidity
When checking the MAX/MIN record, press and hold the
the record.
Notice: It will clear the record at 0:00 every day.

12. CHANNEL SELECT

In normal mode, press the
3 or cycle display. Hold the
search for an RF signal. If the main unit already connect with the outdoor sen-
button to select the temperature unit in C or F.
button to check the alarm time.
or
button to check the MAX and MIN temperature
button to select Channel 1, Channel 2 , Channel
button for approx. 3 seconds to reset values and
button to turn on or turn off
will show on the
button for approx. 3 sec-
button to confirm and continue to
button to clear
EN
23