Setting Up Power Supply; Time Setting; Manual Time Setting - Optus Easy Bedienungsanleitung

7. SETTING UP POWER SUPPLY

Station:
1. Remove the battery compartment cover.
2. Insert the batteries into the battery compartment. Ensure that the battery
polarity (+/-) is correct.
3. Replace the battery compartment cover.
4. Wait until the indoor temperature is displayed on the base station.
Sensor:
1. Remove the battery compartment cover.
2. Set the channel selector switch to the desired channel.
3. NOTE! This weather station can be operated with one or more remote
sensors. Each remote sensor being connected must be operated on a
different channel. If only one remote sensor is connected, it should be
operated on channel 1.
4. Insert the batteries into the battery compartment. Ensure that the battery
polarity (+/-) is correct.
5. Replace the battery compartment cover.

8. TIME SETTING

After the power is restored, the unit automatically searches for the radio sig-
nal. It takes approximately 3-8 minutes for this process to complete.
If the radio signal is received correctly, the date and time are set automatically
and the reception symbol is displayed.
If no radio signal is received, proceed as follows:
1. Press and hold the
activate reception of the radio signal. Reception is now initialized again.
2. If still no radio signal is received, the time must be set manually.

Manual time setting

1. Press and hold
setting mode.
2. Digits to be set are flashing.
3. Press or
changes the values more quickly.
4. Press
5. Settings order: RCC ON/OFF > Time zone (+12 to -12) > 12/24H format >
Hour > Minute > Year > DM/MD > Month > Day > Week language (DE, EN,
FR, SP, IT, DU, DA) > Key tone on/off > Barometer unit (hPa, mmHg, inHg)
6. Finally press the
mode.
22
button on the base unit for approx. 3 seconds to
button for approx. 3 seconds to enter to the time
button to change the value. Holding down the buttons
button to confirm and continue to the next setting.
button to save the settings and exit the setting