Table; Technical / Mounting Information - Mark Pintherm Montage- & Bedienungsanleitung

GB
Technical information
Power
Clock
Switching differential
Dimensions
Weight
Protection
Ambient temperature
External sensor
Installation of the PinTherm
1 Determine a suitable place to install the PinTherm (also refer to the Determining the installation location section).
The temperature
(This is not applicable when an external sensor is used). We recommend positioning the PinTherm at a height of
±1.50m from the
Ensure voltage is not being supplied before connecting the wiring. When there is still power it should be shut
2.
down before installing. Read aiso the manual of the heater on which the PinTherm will be connected before shut
down the power supply.
The electrical connection should be provided based on the applicable standards and
must only be performed by a person qualified for this purpose
Connect the PinTherm according to the supplied electrical diagrams. Select the diagram related to the device
3.
that applies to your situation (see page 8).
Technical information
Room sensor RTFI NTC4,7K (06 29 086)
Sensor
Dimension
Weight
Electrical connection
Protection class
Cabling external sensor
Diameter
0.8mm2
1.Omm2
1.5mm2
2.5mm2
Use a shielded
ATTENTION
Resistance

table

Temp.
-15 -10
NTC 4K7
32.937 25.217
PinTherm
230V-/50Hz
Automatic summer/winter
switching.
IOC
w x h xd = 166 x 160 x 106mm
880 grams
!P54
0-400C
optionai
sensor can be found in the PinTherm and must, therefore, be placed in the room to be heated
floor.
External sensor
NTC 41<7
. 79 x 81 x 26mm
42 grams
0.75-1.5mm3
. IP_30
Length
80 metres
100 metres
150 metres
250 metres
cable.
-5 o 5
19.392 15.040 11.743
Technical I mounting
Determininq
Take the following into consideration when
determining the installation location.
time
- Do not install in direct sunlight.
- Do not install
- Do not install
- The distance
Black bulb sensor RSTF NTC4,7K (06 29 087)
Sensor
Dimension
Weight
Electrical connection
Protection class
Positioninq the sensor
Position draught-free at a distance of 1.5 metres from the
floor. Directly radiated with regard to the black bulb sensor.
10
20 25
15
9.241 7.330 5855 4.700
4
information
the installation
Do not install near a heat source.
on an external
not been insulated.
near a door.
from the floor
±1.50m
NTC 4K7
79 x 81 x 26mm
46 grams
0.75-1.5mm3
I p_30
30 35 40
3.777 3.071 2.512
location
wall that has
should be
45 50
2.066 1.709