Time Setting - Soundmaster Rcd 1150 Bedienungsanleitung

POWER SUPPLY
This set operates on AC (230V
AC OPERATION:
Connect at the back of the unit the AC power cord provided
convenient standard
USING ON batteries
Open the lid of the battery compartment
batteries (not supplied), with the + and — marks correctly aligned, then close the lid.
To switch from AC power supply to battery power supply, disconnect
from the AC inlet, then cisconnect
while the cord is connected.
The batteries need to be replaced
The volume decreases, or sound is distorted during operation.
Notes on batteries
• Do not mix different types of batteries or old batteries with new ones.
• Never recharge the batteries,
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• Attention should be drawn to the environmental
NOTE: In order to avoid leakage, aways remove the batteries when unit will not be
used for a long period oftime.
Before throwing any batteries away, consult your distributor who may be
able to take them back for specific recycling.
TURN ONIOFF
Press the ONfOFF
Slide the FUNCTION
CD and RADIO (AM-FM).
Press the ONfOFF button again to turn the unit OFF. "OFF " indicator will be shown
on the display and then resume the current time.
TIME SETTING
1. In standby mode, press and hold the PLAY MODE/PROGRAWCLOCK-ADJ.
button for 2 seconds , "24H" or "12H " blinks on the display.
2. Press or
3. Press the PLAY MODEIPROGRAWCLOCK-ADJ.
blink. Press the
4. Press the PLAY MODEIPROGRAWCLOCK-ADJ.
digits blink. Press the *
5. Press PLAY MODE/PROGRAM/CLOCK-ADJ.
Note: ":" blinks every second
selected, PM icon is used for the afternoon time.
LISTENING
1. Slide the FUNCTION SWITCH (AM - FM- CD) to AM or FM position.
2. Select your radio station and agust the volume level.
FM: Extend and rotate the antenna when received the s•al
AM: This unit is equipped with a built-in directional ferrite antenna. Rotate the unit to
get the best receiving position.
3. To stop listening to the radio, press ONIOFF to turn off.
VOLUME
Turn VOLUNE +1- control to adjust the sound to comfortable
USING HEADPHONES
Connect a set of stereo headphones with 3.5mm mini plug to the phone jack on the
unit. The speaker are automatically
Note: To establish a safe headphones
setting. Slowly increase the sound until you can hear it comfortably
and without
Maximum output voltage S150 mV
To prevent possible hearing damage,
for long periods.
50Hz)
AC outlet.
main unit. Battery power will be cut automatically
apply heat to them or take them apart.
THE UNIT
button to turn the
SWITCH (AM - FM - CD) to select the audio mode beueen
button to select 12 or 24 hour format.
or button to set
or button to set the minute.
when the time is counting,
TO THE RADIO
(Headphones
distortion.
DC9V
on the back and insert 6 PCS (size C/ I-JM2)
when:
aspects of battery disposal.
unit on.
the hour.
again to cm.plete
Not Included)
cut off when headphones are in use.
sound level: Start your volume control ata low
do not listen at high volume levels
(size C / UM-2 1.5V x 6)
before insett into a
the AC cord
button again, the hour digits
again to confirm, the minute

time setting.

if 12 hours format
is weak.
level.
is
and clearly,