testo 925 Kurzanleitung

testo
testo
Thermometer
Instruction
Probe
aLJAL 1fM
Display
HOLD
key
ON/OFF key
Guide rail for probe
Battery
compartment
Probe input
Measuring instrument conforms
with EN 50081-1 + EN 50082-1
Testo GmbH &
Postfach 1140, D-79849 Lenzkirch
Telefon (0 76 53) 6 81 -O, Ttx (7)76 53 IO=ELRO,
Telex 7 7223 34 eirod, Telefax (0 76 53) 68 11 00
Technical data - instrument
. ...NiCr-NiAI (plug-in thermo-
Sensor:
couple connection type K)
Measuring range• . ....-60 to +1000
(-75 to +1830 OF)
.................±1 OC/±I .8
Accuracy:
(-40 to +900 oc/
-40 to +1650 OF)
00±3.6
(remaining range)
Resolution: . ...0.1 OC/I OC(O.I OF/I OF)
automatic
resolution
to 1 OC(I OF)from +2000C
(+390 OF)
Battery life: ........> 100 h (alcali-mang.)
I-QWbattery display
Switches off automatically
(Auto OFF) after 14 min.
Operating temp • .. .......O to +40 oc
(+32 to +100 OF)
Storage/transport
........... .-20 to +70 oc
temp.
(4 to +155 OF)
Housing material .....ABS
testo 925 instrument. .
Probes.
If the instrument is opened, improperly
handled or if force is applied, no warranty will
be granted!
925
testo 925 is a simple to clean, rugged and
manual
easy-to-use
with a measuring
-60 oc to +1000 0 C (-75 OFto +1830 OF).
The different probes enable the instrument to
be used for a variety of different
applications.
Observe the measuring range of the
sensor! Overheating wili destroy the probe!
Observe permissible storage, transport and
operating temperatures (e.g. protect measu-
Probe handle
ring instrument from direct sunlight).
with guide rail
Avoid applications in aggressive acids or
If the instrument is opened, improperly hand-
Description
Temperature
testo 925.
oc
battery, instruction manual
Temperature
0/0 of m.v.
testo 925 TÜV approved
battery, intruction manual
9 V rechargeable
OF, ± 1 % of m.v.
Charger.
for the external charge of rech. batteries
conversion of
from 0.1 OCPF
Description
Measuring range, t99
Themocouple
-60 to +400 oc (-75 to +750 OF),
Immersion/penetration
-60 to +400 oc (-75 to +750 OF), 10 sec.
Immersion/penetration
-60 to +400 oc (-75 to +750 OF),
Immersion/penetration
-60 to +800 oc (-75 to +1470 OF), 2 sec.
Immersion/penetration
-60 to +400 oc (-75 to +750 OF), 10 sec.
Immersion/penetration
-60 to +400 oc (-75 to +750 OF), 5 sec.
Immersion measuring
Warran
-60 to +1000 oc (-75 to +1830 OF),5 sec.
.......24 months
Immersion
-60 to +1000 oc (-75 to +1830 OF),2 sec.
......12 months
Air probe
-60to+406
Air probe
-60to+400 oc(-75 to+750 OF): 30sec.
Description
temperature measuring instrument
range of
Safety instructions
Please read before
using instrument!
Do not measure on live parts!
solutions.
led or if force is applied, no
warranty will be granted!
Instructions
Insert probe
Observe polarization!
When removing the plug,
never pull on the lead!
Switch on the instrument.
A short display and
segment test follows.
The measuring instru-
ment is now operational.
Ordering data - instrument
.....Part
measuring instrument
. ...0560.9254
measuring instrument
..
............ ...0560.9252
battery. .....0515.0025
. ........0554.0025
Probes
Part no.
.....0602.0644
5 sec.
probe ...0602.0292
probe ........0602.1292
10 sec.
probe .. ..0602.2692
probe ........0602.2292
probe ........0602.3392
tip . .............0602.5792
probe . ..0602.0592
.....0602.1792
io +750 OFj: 40sec.
. . ...0602.9792
Measured values can be held in display
The instrument
automatically after 14 mins (except
when HOLD is activated).
Should the ambient temperature change (e.g.
place of measurement is altered - indoor/out-
door measurements), the measuring instrument
requires several minutes to adapt.
testo 925 enables
in OF. A small switch
to the battery contacts.
of use
Should "Bat" flash in the display, the
battery has a remaining life of approx.
' 10 hours. Should "Bat" be displayed
permanently, the battery should be
replaced within 1-2 hours. The instrument swit-
ches off automatically when the battery voltage
is too low.Remove the old battery and replace
with the new type 9V (IEC 6 F 22) battery
(observe polarization).
no.
Description
Measuring range, t99
Air probe
- 60 to +1000 oc (-75 to +1830 OF),40 sec.
Flue gas probe TÜV approved......0602.9492
-60 to +500 oc
Flue gas probe TÜV approved ......0601.0092
-60 to +500 oc
Surface probe
-60to+400 oc(-75to+750 OF): 30sec.
Surface probe.
-60to+1000 oc675to+1836
Surface probe
-60to+1000 ocG75 io +8830 OF), 20sec.
Surface probe
-60 to +300 oc, short term to +500 oc, 3 sec.
(-75 to +570 OF,short term to +930 OF)
Surface probe
-60 to +300 oc, short term to +500 oc, 3.sec.
(-75 to +570 OF, short term to +930 OF)
Surface measuring
-60 to +1000 oc (-75 to +1830
Surface measuring
-60to+1000 oc(-75 to+1830 OFj: 20sec.
Pipe clamp probe .
-60 to +130 oc, short term to +280 oc, 5 sec.
(-75 to +265 OF,short term to +535 OF)
Surface measuring
-60to+250oc(-75 to+480 OF), 5 sec.
Infrared probe
-18 to + 260 oc (-25 to +500 OF),2 sec.
Handle for measuring
For more information
brochure.
by pressing the HOLD key.
switches off
the user to measure in oc or
is situated on the left next
Move the switch as
required.
Battery replacement
Probes
.... ..Part no.
.....0602.0592
to +930 sec.
to +930 OF),60 sec.
......0602.1992
...0602.0692
20sec.
...0602.0792
..0602.0392
. .0602.0192
tip . ...0602.5292
sec
tip
....0602.5392
..............0602.4592
head ......0602.0092
.0602.0750
tip. ...............0409.1092
get your free testo 925
0973.2180/R/wh/08.95