4. In the "Charger display" section, you will find a table with an explanation of the LED
indicator on the charger.
The battery may get a little warm while charging. That's normal. If the battery cannot
be charged, check:
4.8 whether there is voltage at the socket
4.9 whether there is good contact at the charging contacts
If the battery still can't be charged, send
4.10
4.11
to our customer service center.
To ensure that the battery offers a long life, you should be careful to recharge it
immediately. You will need to charge the battery if you notice that the performance
of the wireless grass cutter is deahaving. Never completely discharge the battery.
This causes a defect to occur.
6. Operation
Follow these instructions to get the maximum performance of your grass cutter:
Never use the grass cutter without protection.
Do not mow grass when it is wet. The best results are achieved with dry grass.
To turn on your grass cutter, press the safety lock (Fig. 1 / Item 1) and then the on/off
switch (Fig. 1 / Item 2).
To turn off your grass cutter, release the on/off switch (Fig. 1 / Pos. 2).
Do not leave the grass cutter near the grass until the switch is pressed, i.e. The grass
cutter is in operation.
To cut properly, swivel the machine sideways as you move forward. Hold the grass
cutter at an angle of about 30° while doing so (see Figs. 10 and 11).
If the grass is long, the grass must be gradually cut shorter from the top (see Fig. 12).
Use the protective hood to avoid unnecessary wear.
To avoid unnecessary wear, keep the grass cutter away from hard objects.
Using the Grass Cutter as a Edge Cutter
To cut the edges of lawns and flower beds, the grass cutter can be converted as
follows:
Remove the battery
Pull the latch for the rotating motor head in the direction of the arrow, as shown in
Fig. 13.
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
22
www.eshopping.de
the charger
and the battery