TecTake 401542 Bedienungsanleitung Seite 12

in the rails underneath the unit, then push it forward until the lock button (10) engages
in the base plate. (B4)
Assembly as grass shears with telescopic
Adjust the telescopic tube to your height: Loosen the handle (23), extend the tube or
return it (B16) and tighten the handle. Mount the cutter on the carriage of the
telescopic handle (18) by sliding the front until it stops. (B5)
The telescopic handle (18) comprises a connecting cable is used to control the shear
from the handle, plug the cable into the socket behind the handle of the shears. (B6)
You can now use the shears while standing.
Mounting box as shears / bush
To mount the blade box (6), remove the lid (9) located on the bottom.
Press the lock button (10) and push the lid (9) back. (B1)
Mount the blade box (6) so that the two guide pins (11) of the transmission are
received in the guide holes (12) of the blade. (B7)
You may need to shift the fine blade (13) in the middle and turn the gear wheel (16) so
as to bring the cam guide (15) in the correct position.
CAUT ION: Always handle boards with gloves!
Once the blade box (6) mounted right between the guide pins (B8), put the lid (9) in
the rails underneath the unit, then push it forward until the button lock (10) engages in
the base plate. (B9)
CAUTION: telescopic handle must not be mounted when the machine is used
as a shear box.
Once the blade box (6) mounted right between the guide pins (B8), put the lid (9) in
the rails underneath the unit, then push it forward until the button lock (10) engages in
the base plate. (B9)
CAUTION: telescopic handle must not be mounted when the machine is used
as a shear box.
CAUTION: This device is a shear box / bush of small capacity, do not use it to
trim hedges
12