Button Function; Instructions For Operation - Merach R05 Benutzerhandbuch

Button Function

MODE- Short press to select
Long press to reset time/times/calories
SET- Set time/count/calorie in non-scanning mode
RESET- Press to reset the set time/times/calories

Instructions for Operation

1.SCAN:
Press the "MODE" button to switch to display "SCAN"
the monitor will switch the display every 6 seconds in
the following sequence: TIME, DIST, CAL, COUNT and
T-CNT.
2.TIME:
(1) Time from start to finish of exercise.
(2) Press the "MODE" button to switch to display "TIME", and press the "SET"
button to set the target exercise time.
When the set time counts down to 0, it will stop for about 1 second and start
counting up.
3.DIST:
Measure the distance from the start to the stop of the movement.
May set up the target objection.
4.CAL:
(1) Calculate the calories burned from the beginning to the end of the exercise.
(2) Press the "MODE" button to switch to display "CAL, and press the "SET" button
to set the target calorie consumption.
When the set calorie countdown reaches 0, it will stop for about 1 second and
start counting up.
5.COUNT:
(1) Display the current exercise times.
(2) Press the "MODE" button to switch the display to "CNT", and press the "SET"
button to set the target number of exercises.
When the set number of times counts down to 0, it will stop for about 1second
and start counting up.
4.T-CNT:
The total number of exercises since the battery was installed
EN
Precautions
1. If the monitor does not display or the display is blurred, please replace the battery.
2. After 4 minutes of inactivity, the monitor will automatically shut down.
3. After restarting the exercise or pressing the button, the monitor will automatically
turn on.
4. After the exercise starts, the monitor will automatically calculate the exercise
data, and stop calculating the exercise data after 4 seconds of stopping the exercise.
Instruction of Monitor
017