Main Unit; Radio Controlled Clock; Manual Time Setting - Vlahova Rb9359 Benutzerhandbuch

A7: Humidity
Part B:
B1: "℃/℉" button
B2: "▲" button
B3: "12/24" button
B4: "MODE/SET" button
Part C:
C1: Wall Mount Hole
C3: Battery Compartment
. Getting Started:

3.1 Main Unit:

Slide open battery compartment cover [C3]
⚫
Insert 4 x AA size batteries observing polarity ["+" and" –" marks].
⚫
Replace battery compartment cover [C3]
⚫
4. Time and Alarm Setting

4.1 Radio Controlled Clock:

After powering on, the clock automatically starts to scan the DCF time signal. Radio Control
⚫
Icon" " flashes on the LCD.
flashes,
Indicating now is receiving
DCF signal
The clock automatically scans the time signal at 3.00 a.m. every day to maintain accurate timing.
⚫
If reception fail, scanning stops ("
The clock can be set to scan the time signal manually by holding "
⚫
Each reception takes about few minutes.
Stop scanning by holding "
⚫
" " shown on the LCD if it is in Daylight Saving Time Mode
⚫

4.2 Manual Time Setting:

In time display mode, press and hold "MODE" button for 3 seconds to enter Clock/Calendar
⚫
setting Mode.
Press "▲"or "▼"button to adjust the setting and press "MODE" button to confirm each setting.
⚫
By keeping the "▲"or "▼"button pressed, could speed up the setting.
A8: Temperature
B5: "RESET" button
B6: "▼/
B7: "
C2: Stand
3
turns on,
Indicating signal received
successfully
" on LCD disappear)
" button for 3 seconds.
" button
" alarm on/off button
disappear,
Indicating signal reception
failed
" button for 3 seconds.
11