GCE LAB 3100 Gebrauchsanweisung Seite 27

FLAME ARRESTOR FS 400
Material: brass (nickel-plated) for C
G 1/4" f. Can be combined with EMD 3100.
FLOWMETER SVM 400
without adaptor, with control valve, allows the specific bleeding of
different flow volumes. Material: black anodized aluminum.
Inlet G 1/4" m, Outlet 6 mm tube fitting. Can be combined with EMD 3100
and EMD 3100.
NOTE!
• Detailed descriptions with advice on ordering can be obtained from
the manufacturer.
4.2. INSTALLATION AND FITTING ACCESSORIES*
*) For detailed descriptions with advice on ordering, check the accessories section of the GCE
catalogue or call our customer service.
**) G 3/8" m > G 3/8"f means: inlet G 3/8" male thread and outlet G 3/8" female thread.
5. INSTALLATION /OPERATION PRESSURE REGULATOR EMD
3100
The EMD 3100 allows you to set the working pressure for a certain consumer. This is done
independently of other consumers connected up to the central gas supply. The EMD 3100 is
provided with an integrated patented shut-off mechanism, replacing an inlet shut-off valve. As
modular option you might attach a regulating valve, which might be used for shut-off purposes
too.
WARNING!
• Disconnect pressure source before disassembling! Toxic, corrosive or flammable gases have
to be purged out before disassembly in order to avoid injuries of the operator. Fire-, explosion-
or intoxication hazard!
5.1. INSTALLING THE PRESSURE REGULATOR
WARNING!
• Check the color code on the handwheel and the gas type and outlet pressure on the rating
plate.
• Only install the pressure regulator if the colour code, gas type and outlet pressure meet your
requirements!
5.1.1. INSTALLATION ON THE WALL ADAPTER WITH G 3/8" F.
Tool: open-end wrench SW 36 (order no. H 11006002). Parts: seal 14 x 9 x 2 mm
PART. NR.
H09010309
H09010309
table 2
H , O , H ;. Inlet G 1/4" m, outlet
2 2 2 2
FLAT SEALING / MATERIAL
D14 x 9 x 2 mm PCTFE / Stainless steel
D14 x 9 x 2 mm PVDF / Brass
27/36
Flammensperre FS400
EN